ASSEMBLY
TW6072 05/05 Assembly Section 3-7
© 2005 Alamo Group Inc.
ASSEMBLY
Check Chains - Extra Equipment - for Lift-Models (Figure Asm-0011)
Check Chains are available for attachment to front of Mower as an accessory. Check chains are used to
control cutting height and especially allow Mower to be lowered to the same preset cutting height effortlessly.
Install lower end of check chain (4) to hitch ears (6) through lower holes (7) using bolts, nuts and
lockwashers(8). Tighten securely.
Install chain lugs (3) on either side of tractor top link mounting (5) using bolt or pin of required diameter and
length. Cat I kit requires a 3/4" diameter bolt. Cat II kit requires a 1" diameter bolt. Install top end of check
chains in brackets (3).
Cutting height is then set by placing proper chain link in keyhole slot. Cutting height is easily adjustable by
hooking chain higher or lower in the keyholes in chain lug (3).
For additional safety in transport, raise mower as high as possible without having driveline hit deck
and shorten check chains as much as possible to prevent inadvertent falling in transport.
To Next Page
Loading...
Need help?
General
