Paper Specifications C-15
OG L 0 1
Do not print within a 5 mm area around the perforations.
Tab Stock
The following sizes and weights of tab stock are supported.
Transparencies
Transparency stock is used primarily to create images that can be used with projection
equipment. Transparencies are made from polyester film that has been specially coated
to allow toner to stick to it. Transparencies cannot be printed in duplex mode.
When using transparencies, the following suggestions may improve performance.
To reduce sticking, fan the transparencies before loading.
If excessive paper jams should occur in the paper path after the fusing process,
load transparencies in the MBT and print them in face-up mode.
Tab Cut Paper Size Paper Weight
3-cut A4/Letter 90 lb/110 lb
5-cut A4/Letter 90 lb/110 lb
8-cut A4/Letter 90 lb/110 lb
5 mm
(0.2 in)
5 mm
(0.2 in)
To Next Page
Loading...
