Paper Handling 3-5
OG L 0 1
3. Adjust the sensor plate to the proper size. Size markers are located on the sensor
plate in the following order: triangle (special), B5, LGR, LGL, LTR, B4, A3, and
A4.
If the paper size you need is not listed, set the sensor plate to triangle (the first
position). Then, in Step 6, you will select the paper size from the OCP display.
4. Place the paper into the tray.
5. Close the tray.
6. If you set the sensor plate to triangle in Step 3, select the paper size from the OCP
by making the following selections:
Printer/Paper Source/Paper Size/tray number/paper size
7. Adjust the paper weight. The default paper weight is 20 lb. bond. If necessary,
change the paper weight by making the following selections:
Printer/Paper Source/
/Paper Weight/tray number
8. Select Index, Bond, or g/m
2
, then use the keypad to input the weight and press .
NOTE:
The paper should be loaded no higher than the Max. level indicator. The
Max. level indicator is located inside the tray.
To Next Page
Loading...
