4-10 Care and Maintenance
OG L 0 1
4. Lock the bottle in place by turning the developer bottle cap about 160 degrees in
the direction shown below.
5. To start the replacement process, make the following selections from the OCP:
Setup / Consumable / Developer Mix / Supply
The replacement process takes approximately 2 minutes. (Maximum replacement
time is 4
½ minutes.)
6. Turn the cap back about 160 degrees in the direction shown and remove the
developer bottle.
CAUTION!
Hold the developer bottle when you turn the cap so that the bottle is not
turned together with the cap.
160°
160
°
To Next Page
Loading...
