Ricoh Aficio 3035 - Removing Punch Waste

Troubleshooting
146
6
y Removing Punch Waste
Note
❒ While “Punch Receptacle Full”
is displayed, you cannot use the
Punch function.
A Open the front cover of the 2 Tray
finisher.
B Pull out the punch waste box, and
then remove punch waste.
C Reinstall the punch waste box.
Note
❒ If you do not, “Punch Recepta-
cle Full
” is still displayed.
D Close the front cover of the 2 Tray
finisher.
“
Punch Receptacle Full” disap-
pears.
Note
❒ If the message is still displayed,
reinstall the punch waste box.
❒ The message “
Punch Recepta-
cle Full
” may appear even
when the punch waste box is
not yet full. If this happens, the
position of the punch waste box
(indicated by the arrow as
shown) may be blocked by
punch waste. Remove the
punch waste.
AHT011S
ZDSO020J
ZDSO030J
ZHVP010J
AdonisC4-AE_zen_F_FM_forPaper.book Page 146 Thursday, May 12, 2005 3:32 PM