The default setting is On.
Warm-up Beeper (copier/Document Server)
You can have the beeper sound when the machine becomes ready to copy after leaving Energy Saver
mode, or when the power is turned on.
The default setting is On.
If the Panel Tone setting is [Off], the beeper does not sound, whatever the Warm Up Notice setting.
Copy Count Display (copier/Document Server)
The copy counter can be set to show the number of copies made (count up) or the number of copies
yet to be made (count down).
The default setting is Up.
Function Priority
Specify the mode to be displayed immediately after the operation switch is turned on, or when System
Reset mode is turned on.
The default setting is Copier.
Print Priority
Print Priority is given to the mode selected.
The default setting is Display Mode.
When [Interleave] is selected, the current print job will be interrupted after a maximum of five sheets.
When the optional Internal Tray 2 (1 bin tray), 1000-sheet finisher, 3000-sheet finisher, or booklet
finisher is installed on the machine, specify an output tray where documents are delivered. For details
about how to specify an output tray for each function, see "Output: Copier", "Output: Document
Server", "Output: Facsimile", "Output: Printer" below.
Function Reset Timer
You can set the length of time the machine waits before changing modes when using the multi-access
function.
This is useful if you are making many copies and have to change settings for each copy. If you set a
longer reset period, you can prevent interruption from other functions.
The default setting is Set Time.
When you select [Set Time], enter the time (3-30 seconds, in 1 second increments) using the number
keys.
The default setting for Function Reset Time is 3 second(s).
The Function Reset Timer setting is ignored if Interleave is set for Print Priority.
Output: Copier (copier)
Specify a tray to which documents are delivered.
2. System Settings
60
To Next Page
Loading...
Need help?
General
