Fax Destination
209
7
Setting label insertion
This section describes how to set label insertion.
When Label Insertion is set to On, the receiver's name and standard messages
are printed on the fax message when it is received at the other end.
A Press [Change] under "Label Insertion".
B Press [On].
C Press [Change] under "Line 2".
D Select a standard message or press [Custom Message] to enter the new mes-
sage.
E Enter the message, and then press [OK].
F Press [OK].
G Press [Change] under "Line 3".
H Select a standard message, and then press [OK].
I Press [OK].
Note
❒ To change the name, key display and title, see “Changing a Registered Name”.
Reference
p.194 “Changing a Registered Name”
Changing a Fax Destination
This section describes how to change a registered fax destination.
A Press [System Settings].
B Press [Administrator Tools].
C Press [TNext].
D Press [Address Book Management].
E Check that [Program / Change] is selected.
To Next Page
Loading...
