Remote Maintenance by telnet
73
2
msh> set nrs
msh> set rfu
msh> set rfu6
msh> set ipp
msh> set ipp6
msh> set http
msh> set http6
msh> set bonjour
msh> set nbt
msh> set ssdp
msh> set ssh
msh> set sftp
msh> set sftp6
❖ Configuration
• Enter “up”to enable protocol,
and enter “down” to disable
protocol.
You can set the protocol to "active"
or "inactive".
msh> set ipv4 {up | down}
• If you disable IPv4, you cannot
use remote access after logging
off. If you did this by mistake,
you can use the control panel to
enable remote access via IPv4.
• Disabling IPv4 also disables
ip1394, lpr, ftp, rsh, diprint,
web, snmp, ssl, ipp, http, bon-
jour, and sftp
msh> set ipv6 {up | down}
• If you disable IPv6, you cannot
use remote access after logging
off. If you did this by mistake,
you can use the control panel to
enable remote access via IPv6.
• Disabling IPv6 also disables
lpr6, ftp6, rsh6, diprint6, ssl6,
ipp6, http6, and sftp6.
msh> set appletalk {up | down}
msh> set netware {up | down}
msh> set smb {up | down}
msh> set lpr {up | down}
msh> set lpr6 {up | down}
msh> set ftp {up | down}
msh> set ftp6 {up | down}
msh> set rsh {up | down}
msh> set rsh6 {up | down}
msh> set diprint {up | down}
msh> set diprint6 {up | down}
msh> set web {up | down}
msh> set snmp {up | down}
msh> set ssl {up | down}
msh> set ssl6 {up | down}
• If Secured Sockets Layer (SSL,
an encryption protocol) func-
tion is not available for the
printer, you cannot use the
function by enabling it.
msh> set nrs {up | down}
msh> set rfu {up | down}
msh> set rfu6 {up | down}
msh> set ipp {up | down}
msh> set ipp6 {up | down}
msh> set http {up | down}
msh> set http6 {up | down}
msh> set bonjour {up |
down}
msh> set ssh {up | down}
msh> set ssdp {up | down}
msh> set nbt {up | down}
msh> set sftp {up | down}
msh> set sftp6 {up | down}
To Next Page
Loading...
Need help?
General
