Forwarding
147
4
E Specify an End Receiver using the destination list, and then press [OK].
The receiver name is shown to the right of [Receiver].
Press the key on the left of the display to switch the destination between fax
number, email address, IP-Fax destination, and folder.
Set a folder destination in Address Book Management under Administrator
Tools in the System Settings menu. See “Registering Folders”.
If you have specified a folder for forwarding, you can specify the file format
used for forwarding. See “Parameter Settings” (switch 21, bit 3).
If you make a mistake, press [Clear] before pressing [OK], and then try again.
F Press [OK].
G Press the {User Tools/Counter} key.
Reference
p.149 “Parameter Settings”
p.235 “Registering Folders”
To Next Page
Loading...
