Special Senders to Treat Differently
163
4
❒ Deleting a destination specified as a forward destination from the destina-
tion list causes the settings of the forward destination to be deleted, so they
must be registered again. When a destination is changed, a document is
transmitted to the new destination. If there is no destination of the speci-
fied type, you can set which destination to be used as an alternative desti-
nation. See “Parameter Settings” (switch 32, bit 0).
❒ After you perform step
J
, set “Forwarding” of “Reception Settings” to
“On”.
Reference
p.149 “Parameter Settings”
p.235 “Registering Folders”
Print 2 Sided
Specify when programming a Special Sender.
A Press [2 Sided Print per Sender].
B Press [On] or [Off], and then press [OK].
Note
❒ Selecting [Same as Basic Settings] will result in the same setting made for “2
Sided Print” of “Reception Settings”.
Memory Lock
Specify when programming a Special Sender.
A Press [Memory Lock Reception per Sender].
B Press [On] or [Off], and then press [OK].
Note
❒ Selecting [Same as Basic Settings] will result in the same setting made for
“Program Memory Lock ID” under “Administrator Tools”.
Paper Tray
Specify when programming a Special Sender.
A Press [Paper Tray per Sender].
B Select the tray you want to use, and then press [OK].
Note
❒ Selecting [Same as Basic Settings] will result in the same setting made for
“Paper Tray” of “Reception Settings”.
To Next Page
Loading...
