7. Re-lock the side fences again.
8. Carefully slide the paper tray fully in.
9. Check the size on the display.
• If you load a paper size that is not selected automatically, you will need to specify the paper size with
the control panel. For details, see “Changing to a Size That Is Not Automatically Detected”.
• p.87 "Changing to a Size That Is Not Automatically Detected"
Changing to a Size That Is Not Automatically Detected
If you load a paper size that is not selected automatically, you need to specify the paper size with the
control panel. This section describes how to load such paper.
This section explains how to load these paper taking 11 × 15 as an example.
1. Press the [User Tools/Counter] key.
Changing the Paper Size
87
To Next Page
Loading...
