Message Causes Solutions
"Some page(s) are near
blank."
The first page of the
document is almost blank.
The original's blank side might have
been scanned. Be sure to place your
originals correctly. For details about
determining the cause of blank pages,
see "Detecting Blank Pages", Fax .
"The selected file(s)
contained file(s) without
access privileges. Only
file(s) with access privileges
will be deleted."
You tried to delete a
document for which you do
not have permission to
delete.
To check your access permission for
stored documents, or to delete a
document you do not have permission
to delete, see Security Guide .
"Updating the destination
list... Please wait. Specified
destination(s) or sender's
name has been cleared."
The destination list is being
updated from the network
using Web Image Monitor.
Wait until the message disappears. Do
not switch off the power while this
message is displayed. Depending on
the number of destinations to be
updated, there may be some delay
before you can resume operation.
Operation is not possible while this
message is displayed.
"You do not have the
privileges to use this
function."
The logged in user name
does not have permission for
the selected function.
For details about how to set
permissions, see Security Guide .
"Authentication with remote
machine failed. Check
remote machine's auth.
settings."
Authentication failed while
using the remote fax
function. The likely causes
are as follows:
• An attempt was made
to connect to a device
that does not support
the remote function.
• User authentication on
the remote machine has
failed.
For details about user authentication,
see Security Guide .
10. Troubleshooting
190
To Next Page
Loading...
Need help?
General
