Ricoh Aficio SP 100SU e - Installation Requirements; Power Requirements

Product Support Guide
Model M101 / M102 / M103
Ver.1.0 Page 4 of 18 6/26/2012
Subject to change without notice
Installation
Installation Requirements
Temperature Range:
15 C to 25 C (59 F to 77 F)
Humidity Range:
30% to 70% RH
Ambient Illumination:
Less than 2,000 lux (do not expose the AIO to strong light, especially direct
sunlight)
Ventilation:
3 times/hr/person
Ambient Dust:
Less than 0.075 mg/m
3
(2.0 x 10-6oz/yd
3
)
Avoid areas exposed to sudden temperature changes:
Areas directly exposed to cool air from an air conditioner.
Areas directly exposed to heat from a heater.
Do not place machine where it will be exposed to corrosive gas or vapor.
Do not install the machine at any location over 2,000m (6,562 ft.) above sea level.
Place the machine on a strong and level base. Inclination on any side should be no more than 5mm (0.2”)
Do not place the machine where it may be subject to strong vibrations.
Machine level
Front to back: within 5mm (0.2”) of level
Right to left: within 5mm (0.2”) of level
Power Requirements
Input voltage level: 110 - 120 V, 60Hz: 6A
Do not place anything on power cord.
The required wall outlet is a NEMA 5-15R (receptacle)
Space
Foot Print
A (Front)
400mm (16”)
B (Left)
100mm (4”)
C (Rear)
200mm (8”)
D (Right)
100 mm (4”)
Dimensions (W x D x H):M101: 402 x 368.5 x 119 mm (15.83” x 14.51” x 4.69”.)
M102: 402 x 368.5 x 163 mm (15.83” x 14.51” x 6.42”.)
M103: 402 x 368.5 x 205 mm (15.83” x 14.51” x 8.07”.)
Note: Measuring conditions: Front door closed. Rear vertical paper tray, not extended.