1. K (black) correction value
Used to adjust the color printed when only black toner is used. The currently set correction value is
printed in red.
2. M (magenta) correction value
Used to adjust the color printed when only magenta toner is used. The currently set correction value is
printed in red.
3. C (cyan)/Y (yellow) correction value
Used to correct the colors printed when cyan and yellow are used. For C/Y (cyan/yellow), the
correction value is determined based on a combination of these two colors, although panel settings are
configured for each color.
4. Setting value
The value displayed is the one currently set when the gradation correction sheet is printed. This value
corresponds to the value set on the control panel.
Resetting the Gradation Correction Value to the Default Value
Press the [Menu] key, and then select the setting items using the [ ] or [ ] key.
1. Select [Maintenance] Press [OK]
2. Select [Quality Maintenance] Press [OK]
3. Select [Color Calibration] Press [OK]
4. Select [Reset Setting] Press [OK]
5. Press [Yes]
When the Printed Color Changes
51
To Next Page
Loading...
Need help?
General