Ricoh AP610N - Aficio B/W Laser Printer - Page 44

Installing Options
40
3
C If the duplex unit is attached,
push down the lever on right side
( ) and pull out the duplex Unit
until it stops ( ).
If the duplex unit is not attached,
go to the following steps.
D Remove the two screws holding
the controller board in place.
Note
❒ Use a coin or similar object if the
screws do not turn easily.
❒ These screws are used again in
fastening the controller board.
E Pull out the handle of the control-
ler board.
F Pull the handle, and then slide
the controller board out.
G Place the controller board on a flat
surface.
ZKGX320E
ZKGX280E
ZKGX370E
ZKGX260E
KirP4GB_Setup-F6_FM_forPaper.book Page 40 Thursday, May 12, 2005 11:28 AM