Installing Options
44
3
D Remove the two screws holding
the controller board in place.
Note
❒ Use a coin or similar object if the
screws do not turn easily.
❒ These screws are used again in
fastening the controller board.
E Pull out the handle of the control-
ler board.
F Pull the handle, and then slide
the controller board out.
G Place the controller board on a flat
surface.
H Remove the two screws and the
cover of the 802.11b interface unit
mounting bracket.
Note
❒ These screws are used again in
fastening the 802.11b interface
unit to the controller board.
❒ The removed cover is not used
when installing the 802.11b in-
terface unit.
I Attach the 802.11b interface unit.
Insert the end of the 802.11b inter-
face unit into the opening ( ), and
then push down until it clicks ( ).
ZKGX280E
ZKGX370E
ZKGX260E
ZKGX410E
ZKGX420E
ZKGX431E
KirP4GB_Setup-F6_FM_forPaper.book Page 44 Thursday, May 12, 2005 11:28 AM
To Next Page
Loading...
