13
AL-C2 Training
Slide 13
Controller Options
Printer/Scanner
The SP model already contains printer and scanner features.
No set-up is needed at installation.
The basic models can be upgraded as follows:
To the basic model, add a printer unit and 512 MB memory, to make a
copier/printer model.
Then, to the copier/printer model, you can add a scanner enhance option,
to make an SP model.
-or –
To the basic model, add a printer/scanner unit and 512 MB memory to
make an SP model.
-also -
To add Document Box to the basic model without upgrading to an SP
model, the optional hard disk must be installed.
The printer enhance option and the printer/scanner option both contain a
hard disk.
It is not possible to install a scanner option without the printer option.
NA models only: Note that the 512 MB memory is included in the printer
and printer/scanner upgrade kits.
The options mentioned on this slide are all new.
The next slide shows the above in a graphic format.
Printer drivers are PCL and PDF direct. Postscript 3 is an option. There is no
RPCS.
The procedures in the service manual for installing printer/scanner and printer
enhance options apply only to the basic model, and not the SP model.
To Next Page
Loading...
