Ricoh D129 - Gigabit Ethernet Board Type a

19
AL-C2 Training
Slide 19
Slots
1. USB-A: Both USB slots can be used
for the Bluetooth option or a card
authentication device.
2. USB-B: Built-in for connection of USB
devices (USB 2.0)
3. SD Card Slot 1 (upper slot)
4. SD Card Slot 2 (lower slot)
5. Ethernet, standard LAN connection
point for a 100BaseT LAN
6. ISDN: Jack for ISDN connection
(Japan Only)
7. Line 3: Jack for a 3rd optional Fax
Interface Unit.
8. Line 1: Jack for the main telephone
line from the outside for connection
to the Fax Option (D596).
9. TEL1: Jack for telephone connection
10. Line 2: Jack for a 2nd optional Fax
Interface Unit.
11. Board Slot: A slot for one optional
interface board.
 Board Slot: One of the following can be installed.
¾ File Format Converter Type E
¾ Gigabit Ethernet Board Type A
¾ IEEE 802.11a/g Interface Unit Type J or IEEE 802.11g Interface Unit Type
K
¾ IEEE 1284 Interface Board Type A
 The SD Card slots are discussed in more detail on the next few slides.