55
AL-C2 Training
Slide 55
New Feature for this Series
Safe Shutdown
In this machine, a board (the SDB) protects the
HDD unit.
After the main power switch of the machine has
been turned off, the SDB keeps the power supply
to the controller until the HDD unit has been
shutdown safely.
When shutting down from normal stand-by
mode, if the safe shutdown takes more than 2
minutes, there is a problem with the controller
board. It may be necessary to replace this board.
This is the same as for AP/AT-C2.5.
This table shows how long it takes to shut down from various machine
conditions.
SDB: Shutdown Board
Less than 80 sDuring 1 min. after
application screen is
displayed
Starting upStarting up
Less than 360 sApplication SD
Removed
Application error
Less than 10 sSC level B, C
Less than 360 sSC level A, DSC issuedError
Less than 360 s
-
Firmware updating
HDD encrypting
Less than 20 s
-
Scanning
Copying/Printing
HDD deleting
Operation
0 sOperation SW off
Less than 10 sStand-by
Panel off
Low power
Stand-byStand-by
Time to Shut DownDetailsStatusMode
To Next Page
Loading...
