56
AL-C2 Training
Slide 56
New Feature for this Series
Printing on Letterhead Paper
This setting changes the paper path.
Off: Simplex pages go through the simplex path and duplex
pages go through the duplex path.
Auto Detect: The paper path for simplex jobs with a paper
type of "Letterhead", "Pre-printed" or "Pre-punched“ is
changed to the duplex path.
On (Always): The paper path for all simplex jobs with all
types of paper is changed to the duplex path.
Simplex pages will still be counted as simplex jobs by the
internal counter even if this setting is enabled.
This is enabled with a printer bit switch.
The purpose of the synchronizing the simplex and duplex paths is so that a
single tray of preprinted paper can be used for both simplex and duplex pages.
With the default setting, at least 2 separate trays are required for preprinted
paper (one for simplex printing and the other for duplex printing). The paper is
loaded face-up in one tray and face-down in the other. This can be a annoyance
for customers.
¾ The default setting is Off is to reduce wear on the duplex unit. The duplex
unit may wear out early when this setting is always enabled. The degree of
extra wear depends on print volume.
¾ Note: If the preprinted paper is the same on both sides, then a single tray
can be used and this setting will probably not need to be changed.
If this feature is enabled, only a single tray of preprinted paper is needed for both
simplex and duplex pages.
To Next Page
Loading...
