Ricoh D146 - Page 746

Main SP Tables-1
System Maintenance Section 2-27 D146/D147/D148/D149/D150
SP Mode Tables
Do not change. Paper feed start permission temp. lower diff from target temp. :
edge: special mode 1
055
Temp.:Upper
Delta:End:Power B
*ENG [0 to 200 / 30 / 1deg/step]
Do not change. Paper feed start permission temp. upper diff from target temp. :
edge: special mode 1
056
Temp.:Lower
Delta:Press:Power B
*ENG
[0 to 200 / D146, D147:77,
D148:71, D149(NA TW): 37,
D149(EU, AS, CHN, KOR): 63,
D150(NA, TW): 25, D150(EU, AS,
CHN, KOR): 43 / 1deg/step]
Do not change. Paper feed start permission temp. lower diff from target temp. :
pressure: special mode 1
057
Rotation Time:Power B *ENG [0 to 100 / 0 / 1sec/step]
Do not change. Paper feed permission setting rotate before decision time:
special mode 1
1105 [Print Target Temp.]
001
Plain1:FC:Center *ENG
[100 to 180 / D146:118, D147:118,
D148:131, D149:147, D150:147 /
1deg/step]
Paper through target temperature: Standard paper 1: FC: center
Fusing malfunction might improve by setting value larger.
Paper curl might improve by setting value smaller.
Adjusting range is +/- 5 deg. celsius.
002
Plain1:FC:Press *ENG
[0 to 200 / D146:118, D147:118,
D148:118, D149:138, D150:138 /
1deg/step]
Do not change. paper through target temperature: Standard paper 1: FC:
pressure