Ricoh D146 - Page 756

Main SP Tables-1
System Maintenance Section 2-37 D146/D147/D148/D149/D150
SP Mode Tables
104
Plain1:BW:Press:Low Speed *ENG [0 to 200 / 118 / 1deg/step]
Do not change. paper through target temperature: Standard 1: BW: pressure:
low speed
105
Plain2:FC:Center:Low Speed *ENG [100 to 180 / 120 / 1deg/step]
Paper through target temperature: Standard 2: FC: center: low speed
Fusing malfunction might improve by setting value larger.
Paper curl might improve by setting value smaller.
Adjusting range is +/- 5 deg. celsius.
106
Plain2:FC:Press:Low Speed *ENG [0 to 200 / 118 / 1deg/step]
Do not change. paper through target temperature: Standard 2: FC: pressure:
low speed
107
Plain2:BW:Center:Low Speed *ENG [100 to 180 / 120 / 1deg/step]
Paper through target temperature: Standard 2: BW: center: low speed
Fusing malfunction might improve by setting value larger.
Paper curl might improve by setting value smaller.
Adjusting range is +/- 5 deg. celsius.
108
Plain2:BW:Press:Low Speed *ENG [0 to 200 / 118 / 1deg/step]
Do not change. paper through target temperature: Standard 2: BW: pressure:
low speed
109
M-thick:FC:Center:Low Speed
*ENG [100 to 180 / 135 / 1deg/step]
Paper through target temperature: middle thick paper: FC: center: low speed
Fusing malfunction might improve by setting value larger.
Paper curl might improve by setting value smaller.
Adjusting range is +/- 5 deg. celsius.
110
M-thick:FC:Press:Low Speed *ENG [0 to 200 / 118 / 1deg/step]
Do not change. paper through target temperature: middle thick paper: FC:
pressure: low speed
111
M-thick:BW:Center:Low
Speed
*ENG [100 to 180 / 135 / 1deg/step]