Ricoh FT5535 - Page 66

Mode No. Function
2-201-xxx Development Bias Adjustments †
2-203 Development Bias Adjustment (for making VSP patterns)
2-206-xxx Development Bias Display †
2-207 Forced Toner Supply (shown as "Compulsory Toner Supply" on the
display)
2-208-001 Toner Supply Mode Selection †
2-208-002 Toner Supply Ratio (TD Sensor Supply Mode) †
2-208-003 Toner Supply Ratio (Fixed Supply Mode) †
2-214 TD Sensor Initial Setting
2-215-xxx TD Sensor Output Display †
2-220 TD Sensor Initial Output Display †
2-222 Toner Supply Ratio
(Detect Supply Mode) †
2-301-xxx Transfer Current Adjustments †
Factory Use Only: Do not change the settings.
2-801 Developer Agitation
2-802 Drum Charge Roller Temperature †
2-812 Drum Reverse Rotation Adjustment †
2-901 Drum Charge Roller Cleaning Interval †
2-902 Not Used
Process Control
3-001 ID Sensor Initial Setting
3-002 ID Sensor Initial Setting Display †
3-103-xxx ID Sensor Output Display †
3-105 Forced V
L Detection
3-106 Initial VLP/VLG Display †
3-107 Current VLP/VLG Display †
3-111 Current VRP/VRG Display †
3-112 Forced VR Detection
3-123 Drum Initialize
3-801 Auto Process Control Mode Selection †
3-901 Free Run (Exposure Lamp Off)
3-902 Forced Process Control
Optics
4-001 Exposure Lamp Voltage Adjustment †
°4-002 Exposure Lamp Voltage Display †
4-008 Vertical Magnification Adjustment †
4-011-xxx Lens Horizontal H.P. Adjustments †
4-013 Scanner Free Run
4-101 Horizontal Magnification Adjustment †
4-102 Lens Error Correction †
4-103 Focus Adjustment †
Rev. 6/16/95
FSM 4-15 FT5535/4527/4522