Ricoh FT5535 - Page 67

Mode No. Function
4-201 Auto ADS Gain Adjustment
4-202 ADS Initial Gain Display †
4-203 ADS Actual Gain Display †
4-301 APS Sensor Function Check †
4-302 Optional APS Sensor (LT version only) †
4-303 APS A5/HLT Detection †
4-901 APS Size Priority (for F4 size) †
•
°4-902 APS 8K/16K Detection (A4 versions only) †
Operation
•
°5-001 All Indicators ON †
•
°5-002 Feed Station Priority Selection †
•
°5-003 APS Priority Selection †
•
°5-004 ADS Priority Selection †
•
°5-013 Counter Up/Down Selection †
•
°5-017 Maximum Copy Quantity †
(Copy Limit)
•
°5-019-xxx Paper Size Set †
•
°5-101 Auto Reset Time Setting †
•
°5-102 Auto Energy Saver Time Setting †
•
°5-103 Auto Tray Shift †
°5-104 A3/DLT Double Count †
•
°5-106 Image Density Level Correction (ADS Correction) †
•
°5-107-xxx Image Shift Margin Adjustment †
•
°5-108 Edge Erase Margin Adjustment †
•
°5-110 Center Erase Margin Adjustment †
°5-113 Coin Lock Installation †
5-115 Duplex Image Shift (Back Side Margin) †
°5-121 T/C (Total Counter) Count Up Timing †
•
°5-305 Auto Off Time Setting †
°5-401 User Code Mode †
•
°5-402 User Code Counter Check †
•
°5-404-xxx User Code Counter Clear †
•
°5-405 User Code Number Setting †
•
°5-407-xxx User Code Number Clear †
°5-408 Number of Registered User Codes Display †
°5-501-001 PM Interval Setting †
°5-501-002 PM Interval Setting (PM Alarm Mode Setting) †
5-504 Used in Japan only. Do not change the factory setting.
5-505 Used in Japan only. Do not change the factory setting.
°5-507 Used in Japan only. Do not change the factory setting.
5-801 Memory All Clear †
FT5535/4527/4522 4-16 FSM