Mainframe Installation
D117/D118 2-10 SM
12. Shake each toner bottle [A] eight or ten times.
13. Install each toner bottle [A] in the machine. The black end, with the label, must go in first,
towards the rear of the machine.
14. Close the front door.
15. Connect the power cord to the machine.
16. Set the paper tray.
17. Turn on the main power.
18. The machine will start the initial settings automatically. This takes about 5 minutes.
19. Wait until the initial settings are terminated and “Ready” is shown on the operation panel.
To Next Page
Loading...
Need help?
General
