● Pull tray 1 completely out. Take care not to drop it.
Squeeze the paper guides on both sides, and then adjust them according to the paper size.
● Beforehand, make sure to squeeze the front end paper guide, and then expand the guide.
Load inkjet transparency into tray 1 with the notched corner in the right front corner of the tray. Do
not load transparencies over the limit mark.
file:///E|/shared/pdf-work/newfiles/pp2w/Op_Guide/int/0007.htm (2 of 4)2005/10/05 12:02:51
To Next Page
Loading...
