● Curled inkjet transparency may jam. Straighten any curls before loading.
● If other paper is loaded, remove it, and then load inkjet transparency.
● To prevent the leading edge of transparencies from being scratched, place transparencies one at a time.
Squeeze the front end paper guide, and then slide it to meet the edge of the inkjet transparency.
Push tray 1 gently in until it stops.
Lower the output tray.
file:///E|/shared/pdf-work/newfiles/pp2w/Op_Guide/int/0007.htm (3 of 4)2005/10/05 12:02:51
To Next Page
Loading...
