Printing > Various Print Functions > Creating a Binding Margin
Creating a Binding Margin
Follow the procedure below to print with a binding margin. If you create a binding margin, it is offset from the
document margin set from the application.
● Since the margin opposite the binding margin will be shifted toward the paper edge, be sure to make this margin wide enough when making
the document.
● If a binding margin is set in an application, do not make this setting in the printer properties. This would result in a binding margin twice as
wide as expected.
1. Open the file you want to print from the application, and then open the printer properties dialog box.
2. Click the [Edit] tab.
3. Select the [Header/Footer/Adjust image position/Binding margins] check box.
4. Click [Details...].
The [Header/Footer/Adjust image position/Binding margins] dialog box appears.
5. In the [Adjust Image Position] area, select the direction in which you want to shift the print area in the
[Direction:] list.
❍ Margins (top, bottom, left, right) change according to the selected direction.
6. Enter a binding margin width, and then click [OK].
❍ To change the measurement unit, click [Measurement Unit...].
7. Make the necessary settings, and then click [OK].
The printer properties dialog box closes.
8. Make print settings, and then click [OK].
● Opening from an Application
Top Previous Next
Copyright © 2005 All rights reserved.
file:///E|/shared/pdf-work/newfiles/pp2w/Op_Guide/acc/0051.htm2005/10/05 12:07:06
To Next Page
Loading...
