Ricoh L5160 - Adjusting the Drop Position

CIP Training L5160/L5130
Basic Operation
2. If the obliqueness of "+10" and "0" is the same, the adjustment value is +5.
+10
0
+
EDP018
3. If the obliqueness of "+10" is greater than 0, the adjustment value is between +1 and +4.
(Enter "+3" for 3.)
+10
0
+
EDP019
After completing the adjustment, perform media feed adjustment again and check that the
adjustment value has been set correctly.
10. Press [Adjustment Amount Entry].
11. Enter the adjustment value that you checked in Step 9 using the number keys, and then
press [Set].
12. Press [Close].
13. Press [Confirm].
14. Press [End].
Adjusting the Drop Position
• Never open the center cover or raise the lever during printing. Opening the
cover or raising the lever will abort printing.
This section explains how to correct misalignment of the ink dropping
position. You can reduce misaligned verticals or blurred colors.
Adjust the drop position if:
• You have changed the thickness of media or the height of the print heads.
• Bidirectional printing produces misaligned verticals or blurred colors.