EasyManua.ls Logo

Ricoh LW426 - Page 191

Ricoh LW426
324 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Message Problem and solutions
DHCP lease time expired. The DHCP lease time has expired. Perform the
DHCP discover again. The IP address you have
been using is no longer available.
DHCP server not found. The DHCP server was not found. Make sure that the
DHCP is on the network.
DHCPv6 server not found. The DHCPv6 server was not found. Make sure that
the DHCPv6 is on the network.
disconnected The supplicant has no connection.
Duplicate IP=<IP address>(from <MAC address>). A conflicting IPv4 or IPv6 address was used. Each
IPv4 or IPv6 address must be unique.
Check the device address in [MAC address].
Established SPX Connection with PServer,
(RPSocket=<socket number>,
connID=<connection ID>)
Connection to the print server was established
when the remote printer went online.
exiting The LPD service has completed and the process is
exiting.
Exit pserver (In the print server mode) The print server function
is disabled because the necessary print server
settings have not been made.
Frametype=<frametype name> The specified frame type name <frame type name>
is for NetWare use.
httpd start. The httpd has started.
IEEE 802.11 Card does NOT support WPA. A wireless card that does not support WPA is
installed. Install a wireless card that supports WPA.
IEEE 802.11 Card Firmware REV.<version> Displays the version number of the 802.11 card's
firmware.
IEEE 802.11 current channel <channel number> Displays the current channel number of the active
wireless card (in ad hoc and infrastructure mode).
IEEE 802.11 MAC Address = <MAC address> Displays the MAC address of the wireless interface.
IEEE 802.11 SSID <ssid> (AP MAC Address
<MAC address>)
The MAC address and SSID of the access point are
connected in infrastructure mode.
Message List
189
4

Table of Contents

Other manuals for Ricoh LW426

Related product manuals