I-fax Switch 04 (SP No. 1-102-005)
No Function Comments
0 Subject for Delivery TX/Memory Transfer
This setting determines whether the RTI/CSI registered on this machine or the RTI/CSI of the
originator is used in the subject lines of transferred documents.
0: Puts the RTI/CSI of the originator in the Subject line. If this is used, either the RTI or CSI is
used. Only one of these can be received for use in the subject line.
1: Puts the RTI/CSI registered on this machine in the Subject line.
When this switch is used to transfer and deliver mail to a PC, the information in the Subject
line that indicates where the transmission originated can be used to determine automatically
the destination folder for each e-mail.
1 Subject corresponding to mail post database
0: Standard subject
1: Mail post database subject
The standard subject is replaced by the mail post database subject in the following three
cases:
1) When the service technician sets the service (software) switch.
2) When memory sending or delivery specified by F code is applied by the SMTP server
3) With relay broadcasting (1st stage without the Schmidt 4 function).
• This switch does not apply for condition 3) when the RX system is set up for memory
sending, delivery by F-code, sending with SMTP RX and when operators are using FOL
(to prevent problems when receiving transmissions).
2-7 Not Used
I-fax Switch 05 (SP No. 1-102-006)
No Function Comments
4. Service Tables
84
To Next Page
Loading...
