When the memory becomes full while using the facsimile function
Message Causes Solutions
"Memory is full. Cannot scan
more. Transmission will be
stopped."
The memory is full. If you press [Exit], the machine returns
to standby mode and starts transmitting
the stored pages. Check the pages that
have not been sent using the
Communication Result Report, and
then resend those pages.
Messages Displayed When Using the Printer Function
This section describes the principal messages that appear on the display panel, error logs or reports. If
other messages appear, follow their instructions.
Status messages
Message Status
"Hex Dump Mode" In Hex Dump mode, the machine receives data in hexadecimal format.
Press [Job Reset] to cancel Hex Dump mode.
"Suspended job exists." Printing was temporarily stopped by SmartDeviceMonitor for Client.
You can resume printing via [My Job List] in SmartDeviceMonitor for
Client, or via the Web Image Monitor. To resume printing via Web
Image Monitor, ask your system administrator first.
"Offline" The machine is offline.
"Please wait." • This message might appear for a second or two while the
machine is preparing, performing initial adjustments, or adding
toner. Wait a while.
• The current environmental condition is outside the recommended
temperature range for the machine. Check the optimum
environmental conditions for the machine and move it to a
different location, or leave the machine for a while and allow it to
adapt to the environment.
"Printing..." The machine is printing. Wait a while.
When Messages Are Displayed on the Control Panel
183
To Next Page
Loading...
