Ricoh P 501 - Page 19

19
CN
EN
准备打印
/Preparations for Printing
确认组件。
•
安装指南（本手册）
•
安全信息
•
光盘
•
电源线
确认环境条件。
•
请将机器安装在机器周围温度和湿度均在上图中所示允许
范围（白色区域）的地方。（蓝色区域：建议范围）
•
请将机器安装在高度差在3 mm以内的水平位置上。
确认空间。
Confirm the components.
• Setup Guide (This manual)
• Safety Information
• CD-ROM
• Power cord
Confirm the environmental conditions.
• Install the machine in a place where the temperature
and humidity around the machine is within the permis-
sible range (white area) shown above. (Blue area: Rec-
ommended range)
• Install the machine on a level spot where the difference
in height is within 3 mm.
Confirm the space.
准备打印
/
列印的準備工作
/Preparations for
Printing
指定是通过网络连接计算机还是通过USB电缆连接
计算机。
•
如果您通过USB电缆连接计算机，请在屏幕上指示
您连接后再连接该电缆。
从 [设备名称] 中选择机器，然后单击 [下一步]。
开始安装。等待 [完成] 画面出现。
pecify whether to connect the computer via a
network or by a USB cable.
• If you connect the computer by a USB cable, do not
connect the cable until you are instructed to do so
on the screen.
Select the machine from [Device Name], and
then click [Next].
Installation starts. Wait until the [Complete] screen
appears.
5 6