CAUTION
Be sure to push the power cord plug fully into the wall outlet. Also, do not •
push it into loose and unstable wall outlets likely to cause a contact failure.
Doing so can result in heat generation.
Be sure to disconnect the plug from the wall outlet and clean the prongs and •
the area around the prongs at least once a year. Allowing dust to build up on
the plug constitutes a fire hazard.
If you do not use the machine for a long period of time such as consecutive •
holidays, be sure to disconnect the power cord plug from the wall outlet for
reasons of safety.
When performing maintenance on the machine, disconnect the power cord •
from the wall outlet for safety.
Power Source•
220–240 V, 6 A or more, 50/60 Hz
Please be sure to connect the power cord to a power source as above.
Requirements during Emergencies
WARNING
Do not touch this machine if a lightning strike occurs in the immediate vicinity. •
Doing so could result in electric shock.
Be sure to install the machine as close as possible to a wall outlet so that you •
can disconnect the power cord plug easily in an emergency.
If the machine behaves unusually as follows, turn off the power immediately. •
After turning off the power, make sure to disconnect the power cord plug from
the wall outlet, and then contact your service representative and report the
problem. Continuously using the power cord can result in fire or electric shock.
The machine is emitting smoke•
The machine is emitting odors•
Metal objects or other foreign objects have fallen inside the machine•
Water or other fluids have fallen inside the machine•
If the machine topples or a cover or other part is damaged, turn off the power •
immediately. After disconnecting the power cord plug from the wall outlet.
contact your service representative. Using the machine continuously can
result in fire or electric shock.
Requirements for Relocating Machines
CAUTION
When moving the machine with the optional paper tray unit attached, do not •
push the upper part of the main unit forcibly. Doing so can cause the main
unit to detach from the optional paper tray unit, possibly resulting in injury.
When carrying or moving the machine by lifting it for relocation to another •
floor, contact your service representative. Dropping or toppling the machine
can result in injury or malfunction.
When moving the machine, make sure to unplug the power cord from the wall •
outlet and confirm that line cords and other connecting cables have been
removed. Otherwise, the power cord is damaged, possibly resulting in fire
or electric shock.
When moving the machine, use the inset grips on both sides, and lift it up
•
slowly in pairs.
The machine may break or cause injury if dropped.
•
The printer weighs approximately 18 kg (40 lb.).
•
Lifting the paper feed unit carelessly or dropping may cause injury.
•
After moving the machine, use the caster fixture to fix it in place. Otherwise,
•
the machine might move or topple over to cause injury.
To Next Page
Loading...
Need help?
General
