Ricoh P800 - Page 117

Message Cause Solution and reference
"Exceeded max. No. of
pages."
While printing a Sample Print,
Locked Print, Hold Print, or Stored
Print file, the maximum page
capacity was exceeded.
• Delete unneeded files stored
in the machine.
• Reduce the number of pages
to print.
"Exceeded max. print size.
Press [FormFeed] or
[JobReset]."
The specified paper size exceeds
the maximum size supported by
this machine.
Press [Form Feed] to force printing
or [JobReset] to cancel printing.
"Exceeded max. print size.
Press [JobReset]."
The specified paper size exceeds
the maximum size supported by
this machine.
Press [JobReset] to cancel printing.
"Failed to connect to server
for Remote Diagnostics."
The machine cannot communicate
with Remote Communication
Gate.
Check the connection to the
Remote Server Gate.
"Independent-supply toner" Independent-supply toner is set. Use the toner recommended for
this machine.
"IPv6 Address already exists
Link-local
Address(109/209)"
The same IPv6 address is already
used.
Consult your network
administrator.
"IPv6 Address already exists
Stateless
Address(109/209)"
The same IPv6 address is already
used.
Consult your network
administrator.
"IPv6 Address already exists
Manual Config.
Address(109/209)"
The same IPv6 address is already
used.
Consult your network
administrator.
"Load paper in (tray name)" There is no paper in the specified
tray.
Load the specified paper in the
tray, press [JobReset] to reset the
job.
"No privileges to use funct." The logged in user does not have
the privileges to register programs
or change the paper tray settings.
Check the privileges.
see "Registering Administrators
Before Using the Machine", User
Guide (Full Version).
"Parallel I/F Error" The machine's self-diagnostic test
failed due to a loopback error.
Replace the IEEE 1284 board that
caused the error.
Alert Messages that Appear on the Control Panel
115