7
119
Appendix
Autofocus does
not work.
The subject
is difficult
to focus on.
v cannot work well for low-
contrast objects (the sky,
white walls, etc.), dark colors,
intricate designs, rapidly-
moving objects or scenery shot
through a window or a net-like
pattern.
Lock focus on another object
located at the same distance
as your subject, then aim
at the target and take a picture.
Alternatively, use w.
The subject is too
close.
Move away from the subject
and take a picture.
The focus cannot
be locked.
AF Mode of Live
View is set to f.
Set [Contrast AF] to e, g,
h, or i. (p.57)
The built-in flash
does not
discharge.
The flash mode is
set to A or B.
When the flash mode is set
to A or B, the flash does
not discharge if the subject
is bright.
Change the flash mode. (p.53)
The camera is not
recognized when it
is connected to a
computer.
The USB
connection mode
is set to [PTP].
Set [USB Connection] to [MSC]
in the D2 menu.
Dust or dirt
particles appear in
images.
The CMOS sensor
is dirty or dusty.
Activate [Dust Removal] from
the D4 menu. The Dust
Removal function can be
activated every time the camera
is turned on and off.
Refer to “Sensor Cleaning”
(p.120) if the problem persists.
Problem Cause Remedy
There are visible
defects in a
captured image,
or parts in the
display monitor
that do not light up
or remain lit.
There are
defective pixels in
the CMOS sensor.
Activate [Pixel Mapping]
from the D4 menu.
It takes about 30 seconds
to correct the defective pixels,
so be sure to install a fully
charged battery.
Problem Cause Remedy
KS2_OPM_EN.book Page 119 Friday, February 20, 2015 12:10 PM
To Next Page
Loading...
