Why does the lamp on my Ricoh Projector turn off?
If your Ricoh Projector's lamp turned off during operation, or does not turn on, it could be due to overheating, the lamp's service life expiring, or a malfunction. Try disconnecting the power cord, waiting a while, and then turning the projector back on. If the lamp burns out, replace it with a new one.
What to do if Ricoh PJ X3340 shows temperature error?
If your Ricoh Projector turned off during operation and displays a "Temperature Error", it may be due to overheating or use in a high-temperature environment. Ensure that the intake and exhaust vents are not blocked to allow for proper ventilation. Disconnect the power cord, wait a while, and then turn the projector on again.
Why Ricoh Projector turned off during operation if lamp cover is not installed correctly?
If your Ricoh Projector turned off during operation, because the lamp cover is not installed correctly, disconnect the power cord, and reinstall the lamp cover correctly.
Why the lamp does not turn off on Ricoh Projector?
If the lamp does not turn off on your Ricoh Projector, the projector has likely malfunctioned. Disconnect the power cord, wait a while, and then turn the projector on again. If the problem persists, contact your service representative.
What to do if my Ricoh PJ X3340 has no image?
If your Ricoh Projector shows no image, ensure the input signal is correctly switched if [Auto Input Search] in [Default Settings 1] is set to [Off]. Also, check that the mute function is not turned on and verify the [Brightness] settings in [Image Adjustment]. Confirm that your computer or AV equipment is correctly connected and functioning properly. Finally, ensure the computer's image output is correctly switched.
What to do if Ricoh Projector operation keys do not respond?
If the operation keys on your Ricoh Projector do not respond, ensure that [Key Lock] in [Default Settings 2] is not set to [On].
How to fix Ricoh Projector when 'Fan Error' is displayed?
If your Ricoh Projector displays a 'Fan Error' and turns off, the cooling fan in the projector has likely malfunctioned. Disconnect the power cord and contact your service representative.
What to do if Ricoh Projector image is not projected normally?
If the image from your Ricoh Projector is not projected normally, ensure the input signal is compatible with the projector. Check the status of the video tape or other video source. Execute [Auto Set Signals] in [Image Adjustment]. Check the settings of the computer's graphics driver.
Why Ricoh Projector power does not turn on?
Make sure the power plug or connector of your Ricoh Projector is connected correctly and the lamp cover is mounted correctly.
Why 'Hardware Error' on Ricoh PJ X3340?
If your Ricoh Projector displays 'Hardware Error' and turns off, it has likely malfunctioned. Disconnect the power cord, wait a while, and then turn the projector on again. If the problem persists, contact your service representative.
General| Resolution | XGA (1024 x 768) |
|---|---|
| Max Resolution | UXGA (1600 x 1200) |
| Display Technology | DLP |
| Video Compatibility | NTSC, PAL, SECAM |
| Projection Size | 30 - 300 inches |
| Lamp Type | UHP |
| Connectivity | HDMI, VGA, USB |
| Zoom Ratio | 1.1x |
| Keystone Correction | Vertical ±30 degrees |
| Aspect Ratio | 4:3, 16:9 |
| Output Ports | Audio Out |
| Noise Level | 29 dB (Eco mode) |
| Lamp Life | 5000 hours (Normal) / 6000 hours (Eco) |
To Next Page
