How to fix color is faded on Ricoh Projector?
If the color on your Ricoh Projector is faded or the tint is poor, check the [Color Saturation], [R-level], [G-level], and [B-level] settings in [Image Adjustment]. Ensure the screen is clean and check the settings of [Wall Color Mode] in [Display Settings]. Also, make sure the lamp is not near the end of its service life.
How to fix dark image on Ricoh Projector?
If the image on your Ricoh Projector is dark, check the [Brightness] and [Contrast] settings in [Image Adjustment]. Also, ensure the lamp is not near the end of its service life. Verify the settings of [RGB Input Range] in [Image Adjustment] and make sure [3D Projection] in [Display Settings] is set to [Off].
What to do if Ricoh Projector lamp turned off during operation?
If the lamp in your Ricoh Projector turned off during operation, it may have overheated, reached the end of its service life, or the projector may have malfunctioned. Disconnect the power cord, wait a while, and then turn the projector on again. If the lamp burns out, replace it with a new one.
How to fix blurred image on Ricoh PJ X3340?
If the image on your Ricoh Projector is blurred or partially out of focus, ensure the lens is clean and adjust the focus. Verify the projection distance is within the projector's range and check the installation angles of the projector and screen. Also, check the settings of [Sharpness] and [Phase] in [Image Adjustment].
How to fix Ricoh PJ X3340 Projector when 'Temperature Error' is displayed?
If your Ricoh Projector displays a 'Temperature Error' and turns off, it might be overheating or being used in a high-temperature environment. Ensure the intake and exhaust vents are not blocked. Disconnect the power cord, wait a while, and then turn the projector on again.
Why Ricoh PJ X3340 turns off during use?
If your Ricoh Projector turns off during use, ensure that the environment in which the projector is being used is within the acceptable temperature range and the vents are not blocked.
What to do if my Ricoh Projector shows no sound?
If there is no sound from your Ricoh Projector, try the following: Press the [Input] button. Make sure the mute function is not turned on. Check the speaker's volume adjustment. Ensure that the computer or AV equipment is correctly connected to the projector and working properly.
How to change display language on Ricoh PJ X3340 Projector?
To change the display language on your Ricoh Projector, press the [Menu] button, and then select the display language in [Language / XXX] (XXX indicates the current display language) on the [ ] tab.
General| Resolution | XGA (1024 x 768) |
|---|---|
| Max Resolution | UXGA (1600 x 1200) |
| Display Technology | DLP |
| Video Compatibility | NTSC, PAL, SECAM |
| Projection Size | 30 - 300 inches |
| Lamp Type | UHP |
| Connectivity | HDMI, VGA, USB |
| Zoom Ratio | 1.1x |
| Keystone Correction | Vertical ±30 degrees |
| Aspect Ratio | 4:3, 16:9 |
| Output Ports | Audio Out |
| Noise Level | 29 dB (Eco mode) |
| Lamp Life | 5000 hours (Normal) / 6000 hours (Eco) |
To Next Page
