What to do if 'Multi-sheet fold is not available with the selected fold type' on Ricoh Pro 1107EX?
If your Ricoh printer displays 'Multi-sheet fold is not available with the selected fold type', press [Job Reset] to cancel the print job, and then check the printer driver settings. This issue occurs when multi-sheet fold was specified with a fold type that cannot be used when multi-sheet folding.
What to do if Ricoh Pro 1107EX Printer shows 'Problem with Hard Disk'?
If you see the message 'Problem with Hard Disk' on your Ricoh printer, switch the machine's main power off and then back on. If the message persists, this indicates a hard disk error, and further assistance is needed.
How to solve 'IPv4 Address is already in use' on Ricoh Pro 1107EX Printer?
To resolve the issue of 'IPv4 Address is already in use' on your Ricoh printer, ensure that the system's IPv4 address specified for the machine is correct.
What to do if paper settings of Tray n do not match specified paper size on Ricoh Printer?
If your Ricoh Printer displays 'Paper settings of Tray n do not match specified paper size', configure the paper settings of the selected paper tray to match the specified paper size. This issue occurs because the configured paper settings for the selected paper tray do not match the specified paper size.
What to do if Ricoh Printer displays 'Error has occurred'?
If your Ricoh printer displays 'Error has occurred', press [Job Reset] to cancel the print job, and then check the printer driver settings. This is because an invalid printing parameter has been specified.
How to fix 'Paper settings of the Interposer Upper Tray do not match the specified paper size' on Ricoh Pro 1107EX Printer?
To resolve the 'Paper settings of the Interposer Upper Tray do not match the specified paper size' error on your Ricoh printer, configure the settings of the displayed paper to match the specified paper size. This issue occurs because the paper settings configured for the selected interposer tray do not match the specified paper size.
How to resolve 'Cannot print with current tray paper settings' on Ricoh Pro 1107EX?
If your Ricoh printer displays 'Cannot print with current tray paper settings', check the tray paper settings. This problem occurs because tray paper settings are incorrect.
How to resolve 'Reset Tray n correctly' error on Ricoh Pro 1107EX Printer?
If your Ricoh printer displays 'Reset Tray n correctly', install the paper tray correctly, or press [Job Reset] to cancel the print job. This issue occurs when the selected paper tray is not installed or is installed incorrectly.
What to do if Ricoh Pro 1107EX displays 'Selected paper size is not supported'?
If your Ricoh printer shows 'Selected paper size is not supported', press [Job Reset] to cancel the print job, and then set the paper size correctly. This is because an unsupported paper size was specified for a PostScript print job.
What to do if paper tray is overloaded on Ricoh Printer?
If you encounter the message 'Make sure that the paper tray is not overloaded and the paper is set correctly' on your Ricoh printer, load paper only as high as the upper limit markings of the paper tray, or load paper correctly. This issue occurs when the paper tray is overloaded, or the paper is not set correctly.
To Next Page
General
