If misfeeding of paper occurs when using loose paper such as thin or coated paper, increase the mask
width. This will increase the unprinted area at the leading edge, trailing edge, left edge, or right edge of
the paper and facilitate paper separation from the fusing belt.
Press [+] or [−] to adjust the mask width.
Setting Items
Default
Value
Max.
Value
Min.
Value
Step Unit
[Adjust Erase Margin of Leading
Edge]
0.0 6.0 -3.0 0.1 mm
[Adjust Erase Margin of Trailing
Edge]
0.0 6.0 -9.0 0.1 mm
[Adjust Erase Margin of Left Edge] 0.0 6.0 -9.0 0.1 mm
[Adjust Erase Margin of Right Edge] 0.0 6.0 -9.0 0.1 mm
• This setting is not effective for paper fed from paper trays with custom paper presets. For such
paper, the value specified in [Adjust Erase Margin of Leading Edge], [Adjust Erase Margin of
Trailing Edge] in [Advanced Settings] takes precedence.
Setting Values
27
To Next Page
Loading...
