0203: [Adjust Maximum Image Density]
Specify the adhesion of toner to the drum surface and intermediate transfer belt when image density
adjustment is executed.
If color reproduction is affected by the toner's color intensity difference, adjust the toner adhesion.
After specifying this setting, execute [Adjust Image Density/DEMS].
Press [+] or [−] to adjust the toner adhesion.
Setting Items
Default
Value
Max.
Value
Min.
Value
Step Unit
[Black] 0 5 -5 1 None
[Cyan]
[Magenta]
[Yellow]
• Increasing the toner adhesion might reduce fusibility, causing toner splatter or distorted text and
thin lines.
0204: [Adjust Line Width]
Adjust the intensity of the laser for transferring image data to the drum.
If you increase the laser intensity, the line width is increased. By adjusting the laser intensity, you can
adjust the line width.
After specifying this setting, execute [Adjust Image Density/DEMS].
Press [+] or [−] to adjust the laser intensity.
Setting Items
Default
Value
Max.
Value
Min.
Value
Step Unit
[Black] 0 5 -5 1 None
[Cyan]
[Magenta]
[Yellow]
Setting Values
29
To Next Page
Loading...
