Ricoh Pro C5110S - Page 453

092 Custom Paper 092 ENG [-4.0 to 4.0 / 0.0 / 0.2mm/step]
093 Custom Paper 093 ENG [-4.0 to 4.0 / 0.0 / 0.2mm/step]
094 Custom Paper 094 ENG [-4.0 to 4.0 / 0.0 / 0.2mm/step]
095 Custom Paper 095 ENG [-4.0 to 4.0 / 0.0 / 0.2mm/step]
096 Custom Paper 096 ENG [-4.0 to 4.0 / 0.0 / 0.2mm/step]
097 Custom Paper 097 ENG [-4.0 to 4.0 / 0.0 / 0.2mm/step]
098 Custom Paper 098 ENG [-4.0 to 4.0 / 0.0 / 0.2mm/step]
099 Custom Paper 099 ENG [-4.0 to 4.0 / 0.0 / 0.2mm/step]
100 Custom Paper 100 ENG [-4.0 to 4.0 / 0.0 / 0.2mm/step]
6762
[Top Tray Full Set: Enable]
Sets whether to execute Full Detection for output paper in Fold machine tray.
Detected when Fold machine tray becomes full if [Full Detection ON] is set and alert
message is displayed after the set number of pages are printed out with [SP6-763-001:
Top Tray Full Set: Limit Output Multi Folder].
* This setting is synchronized with Adjustment Items for Special Operator [Fold Machine
Tray Full Detection] in Pro machine.
001 - ENG [0 or 1 / 0 / 1/step]
6763
[TopTray Full Set:Limit Output]
Sets Print Page until when the alert message is displayed when Fold machine tray detects
Full.
Setting the large number of Print Page avoids stopping printing by early detection of Full
and increases productivity as it delays displaying an alert message.
The number of "1" when Multi Sheet is specified is counted as "1" page.
It becomes enabled that [SP6-762-001: Fold Machine Tray Full Detection ON/OFF
Setting Multi Folder] is set for [Full Detection ON].
Delaying to display the alert message may cause disordered loaded paper and paper
jams because the exit is obstructed by output paper.
* This setting is synchronized with Adjustment Items for Special Operator [Fold Machine
Tray After Full Detection Output Number] in Pro machine.
SP6-XXX (Peripherals)
451