Ricoh Pro C5110S - Page 454

001 - ENG [0 to 250 / 0 / 1/step]
6801
[1-pass Stamp Unit]
Sets Attached/Not Attached for Stamp Unit.
001 - *ENG
[0 or 1 / 0 / 1/step]
0: Attached
1: Not Attached
6830
[Extra Staples]
More than the standard number of sheets can be stapled. This SP sets the additional
number of sheets (This Setting + Standard Number = maximum number of sheets).
•
If the number of the maximum for staples is increased, and the mechanical warranty of
the unit can be guaranteed, then the setting can take effect without changing the
controller software.
• However, assurance that mechanical performance can be guaranteed is required
before changing the setting to increase the staple load for more than the maximum in
the feed/exit specifications. Raising this setting without quality assurance could
damage the machine.
001 0 to 50 (Initial:0) *CTL [0 to 50 / 0 / 1/step]
6830
[Extra Saddles]
Makes possible for staple to saddle stitch more sheets than basic amount.
Saddle stitch staple max. amount will be recognized as the total of this SP’s value and the
basic amount.
002 0 to 50 (Initial:0) *CTL [0 to 50 / 0 / 1/step]
6830
[Extra Half-Fold]
Makes possivle for finisher to middle fold more than the basic foldable amount.
Middle fold max. amount will be recognized as the total of this SP’s value and basic
Middle fold amunt.
003 0 to 50 (Initial:0) *CTL [0 to 50 / 0 / 1/step]
6890 [Punch Function Enabled (Z Fold)]
4. Main SP Tables-6
452