Ricoh Pro C5110S - Page 455

001 0: No Punch 1: Punching OK CTL
[1 to 0 / 0 / 1/step]
0: No Punch
1: Punching OK
6900
[ADF Bottom Plate Setting]
Changes Bottom Plate Mode.
001 - *ENG
[0 or 1 / 0 / 1/step]
0: Bottom Plate (Default) by Original set
1: Bottom Plate by Feed/Exit Paper
Signal
6925
[SoftRollerPress QuantityTuning]
Fine-tunes Decurler Roller Pressure ranging from +0.5 - -0.3mm with normal operation
(other than Custom Paper).
•
Increases or decreases the specified value to the pressure in Decurler Pressure level
(Level 1-5).
• Plus value: Curl UP Correction
• Minus value: Curl Down Correction
001 - ENG [-0.3 to 0.5 / 0.0 / 0.1/step]
6926
[DecurlerSpeed Quantity Tuninng]
Fine-tunes Decurler Speed Quantity ranging from +3.0 - -3.0%.
Increases or decreases the specified ratio to each Speed Quantity.
•
Plus value: Speed Quantity UP Correction
• Minus value: Speed Quantity Down Correction
001 - ENG [-3.0 to 3.0 / 0.0 / 0.1%/step]
6928
[Soft Roller Press Quantity Set] *D137/D138 only
Sets Decurler Roller Pressure level (Level 1-5) with Custom Paper.
• Level 1 (Curl Correction Weak) - Level 5 (Curl Correction Strong)
001 Custom Paper001 ENG [1 to 5 / 1 / 1/step]
SP6-XXX (Peripherals)
453