Ricoh Pro C5110S - Page 724

011
Skew Correction ENG [0 or 1 / 0 / 1/step]
Acquires Sensor information for ADF. Turns to "1" when the original is in Sensor part.
012
Scan Entrance Sensor ENG [0 or 1 / 0 / 1/step]
Acquires Sensor information for ADF. Turns to "1" when the original is in Sensor part.
013
Registration Sensor ENG [0 or 1 / 0 / 1/step]
Acquires Sensor information for ADF. Turns to "1" when the original is in Sensor part.
014
Exit Sensor ENG [0 or 1 / 0 / 1/step]
Acquires Sensor information for ADF. Turns to "1" when the original is in Sensor part.
015
Feed Cover Sensor ENG [0 or 1 / 0 / 1/step]
Acquires Sensor information for ADF. Turns to "1" when Cover is opened.
016
Lift Up Sensor ENG [0 or 1 / 0 / 1/step]
Acquires Sensor information for ADF. Turns to "1" when Lift Up is detected.
018
Pick-Up Roller HP Sensor ENG [0 or 1 / 0 / 1/step]
Acquires Sensor information for ADF. Turns to "1" when Pick-Up Roller is not in HP.
021
Bottom Plate HP Sensor ENG [0 or 1 / 0 / 1/step]
Acquires Sensor information for ADF. Turns to "1" when Bottom Plate is not in HP.
022
Bottom Plate Position Sensor ENG [0 or 1 / 0 / 1/step]
Acquires Sensor information for ADF. Turns to "1" when Pick-Up Roller is not in Feed
Position.
023
Original Length 4 (LT/A4 Tail
Sensor)
ENG [0 or 1 / 0 / 1/step]
Acquires Sensor information for ADF. Turns to "1" when the original is in Sensor part.
6123 [INPUT Check: 2K/3K FIN]
001
Entrance Sensor ENG [0 or 1 / 0 / 1/step]
Acquires Sensor information for the specified sensors. Displays signal level for Sensors as it
is.
7. Input and Output Check
722