Ricoh Pro C5110S - Page 781

110
Inverter Ent Mtr:Exit Speed2:Low
Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
111
Exit/Inverter Mtr:CW:Exit
Speed1:Std Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
112
Exit/Inverter Mtr:CW:Exit
Speed1:Mid Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
113
Exit/Inverter Mtr:CW:Exit
Spd1:Mid-Low Spd *D136 only
ENG [0 or 1 / 0 / 1/step]
This SP is only for D136 machine. Executing this SP on D135/D137/D138 machines may
cause SC error.
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
114
Exit/Inverter Mtr:CW:Exit
Speed1:Low Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
115
Exit/Inverter Mtr:CWW:Exit
Speed1:Std Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
116
Exit/Inverter Mtr:CWW:Exit
Speed1:Mid Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
117
Exit/Inverter Mtr:CWW:Exit
Spd1:Mid-Low Spd *D136 only
ENG [0 or 1 / 0 / 1/step]
This SP is only for D136 machine. Executing this SP on D135/D137/D138 machines may
cause SC error.
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
Output Check Table
779