Ricoh Pro C5110S - Page 787

160
Duplex Feed Mtr:Feed
Speed2:Low Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
161
Duplex Feed Mtr:Std Speed ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
162
Duplex Feed Mtr:Mid Speed ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
163
Duplex Feed Mtr:Mid-Low Speed
*D136 only
ENG [0 or 1 / 0 / 1/step]
This SP is only for D136 machine. Executing this SP on D135/D137/D138 machines may
cause SC error.
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
164
Duplex Feed Mtr:Low Speed ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
165
Duplex Feed Mtr (Hold) ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
166
Duplex Exit Mtr:Feed Speed1::Std
Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
167
Duplex Exit Mtr:Feed
Speed1::Mid Speed
ENG [0 or 1 / 0 / 1/step]
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
168
Duplex Exit Mtr:Feed
Speed1::Mid-Low Speed *D136
only
ENG [0 or 1 / 0 / 1/step]
This SP is only for D136 machine. Executing this SP on D135/D137/D138 machines may
cause SC error.
Operates load for Motors and SOL etc. Pay attention to ON time due to forced load-ON.
Output Check Table
785