Ricoh Pro C5200 Series - Page 98

CIP Training Pro C5200 series
Adjustment Settings for Operators
No. Item Description
033 [Textured Paper Mode
Voltage: BW: Side 1]
Adjust the voltage applied to the paper for paper transfer
pa^gikbgmbg`bg^Z\aikbgmfh]^"\hehk)[eZ\d'Zg]'
pabm^&hg^'lb]^)]nie^q#pbmaN^qmnk^]JZi^kfh]^
enabled.
034 [Textured Paper Mode
Voltage: BW: Side 2]
035 [Textured Paper Mode
Voltage: FC: Side 1]
036 [Textured Paper Mode
Voltage: FC: Side 2]
Fuser Adjustment
For details about the following items, see page 134 "Fuser Adjustment".
No. Item Description
050 [Fusing Temp] Adjust the heat roller temperature.
051 [Fusing Pressure Roller
Temp]
Adjust the pressure roller temperature.
052 [Fusing Nip Width Setting] Adjust the nip width between the fusing belt and pressure
roller.
053 [Fusing Temp to Feed Ppr] Adjust the fusing temperature at which to allow paper
feeding after warming up.
054 [Additional Fusing Temp
1]
Adjust the fusing unit's accumulated temperature for a
specific time after a job starts.
055 [Additional Fusing Temp
2]
Adjust the fusing unit's accumulated temperature for a
specific time after writing starts.
056 [Cleaning Web Rotation
Interval]
Specify the interval between each activation of the
cleaning web.
057 [Cleaning Web Contact
Position]
Specify how the cleaning web comes into contact and
separates.
058 [Fusing Nip Width
Adjustment: Envelope]
Adjust the nip width between the fusing belt and pressure
roller when an envelope is being fed.
100 [Paper Feed Interval
Setting]
Adjust the interval between the feeding of each sheet.