Technical Bulletin PAGE: 2/3
Model: Vacuum Feed LCIT RT5100
2. Apply engine oil to the right side of the side fence shaft (positions are marked by red
stars in Fig. 2).
Fig. 2
IMPORTANT:
Apply the oil as 3 large drops for each shaft, near the shaft bearing, as shown
in Fig. 3.
You only need to apply the oil to the right side of each shaft. This is because
POM bearings are used on the left side, and these are not affected by paper
dust. (Dry bearings are used on the right side).
The recommended oil is JOMO GP-S 10W-30 produced by Japan Energy. If
you use another oil, make sure it has the viscosity of 10W-30.
Fig. 3
To Next Page
Loading...
