Technical Bulletin PAGE: 4/4
Model: Vacuum Feed LCIT RT5100
7. Loosen the screw shown below.
Note:
This screw is located inside the round hole in the side plate on the operator side
of the machine.
Fig. 6
8. Loosen the screw shown below.
Note:
This screw is located on the non-operator side of the machine.
Fig. 7
9. Adjust the side fences into the correct position (within 2.0mm).
10. Hold the side fences in place while you tighten the two screws mentioned in Steps 7
and 8.
11. Do the same correction for the other side fence.
12. Reassemble the tray and measure the spans again to make sure they are within
specification.
To Next Page
Loading...
